Sanwa SE9100, Инструкция по эксплуатации, Страница: 33 / 44

－ …29…－
Press the CH1 button or the CH2 button to select a memory No.
and press the ENT button. The CH1 display shows the CH1 hold
value and the CH2 display shows the CH2 hold value (a measure-
ment unit LED lights). [
] is displayed if no hold value is
saved in memory. Pressing the ENT button again displays the maxi-
mum value (with measurement unit LED) on the CH2 display.
To clear the saved data from memory, press the SAVE button while
[ ] is displayed in the CH1 display in the data recall status. The
CH1 display shows [ ] and the CH2 display shows [ ]. Now
press the CH1/CH2 button so that the CH2 display shows [ ]
and then press the ENT button to clear the data.
Note that it is not a single set of data that is cleared but that all data
is cleared simultaneously.
In case of mm
Flashing
CH2: Max value display
Memory clear
Setting mode (See 5-2)
Memory recall starts.
Memory data is displayed.
No data
In case of m/min or r/min
When there is no data
(Example: No data in CH2)