12
Instruction Manual for Sanuvair
®
S300
1-888-726-8869
www.sanuvox.com
STEP 5
5. Then, slide the porcelain tip through the retention clamp.
NOTE: Make sure the lamp is horizontal in this section and not touching
the metal walls.
STEP 6
6. Screw back in place the access door for the lamp and ballast over the
rectangular opening.
How to Replace Filters
Replace prefilter every 3 to 6 months or as needed.
Replace HEPA filter every 1 to 3 years or as needed. Check regurlarlyto maintain maximum performance of your HVAC system.
Step by Step Filter Replacement
1.
Open the filters and motor access door at the front of the unit.
Opening the latch on the right side of the unit will permit the door to
swing open.
If necessary the door can be removed from the cabinet hinges by holding
the top part of the door with one hand and gently tapping on the bottom
edge of the door with your hand to release the door from its hinges.
2. After opening the unit’s access door,
grasps both edges of the HEPA
filter and pull with equal force to slide it out
.
3. Unpack the new HEPA filter and place it in the unit, then close the
access door. Repeat step 2 and 3 for the pre-fitler, as needed.
NOTE:
Make sure to install filters according to air flow direction for
maximum performance.
STEP 1
STEP 2
STEP 3
