6901-002156 <01>
7
2
Mount the Wall Plate
Solid concrete or concrete block
2-1 Mark the wall
2-2 Drill pilot holes
2-3 Insert anchors and lag bolts
CAUTION:
Avoid potential injuries or property damage!
Ù
Pilot
holes
MUST
be
drilled
to
a
depth
of 63.5
mm
(2½
in.)
using
a 13
mm
(1/2
in.)
diameter
drill
bit.
Ù
Never
drill
into
the
mortar
between
blocks.
For assistance in determining wall plate location, see Height
Finder at sanus.com.
Level the wall plate
[01]
and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!
Ù
Mount the wall plate
[01]
directly onto the concrete surface.
Ù
Minimum solid concrete thickness: 8 in.
Ù
Minimum concrete block size: 8 x
8
x 16 in.
Ù
If wall plate
[01]
is extended, ensure at least two lag bolts
[02]
washers
[03]
and anchors
[04]
are fastened to each of
the three plates.
Ù
Minimum horizontal space between fasteners: 406 mm(16
in.).
[04]
13 mm
(1/2 in.)
13 mm
(1/2 in.)
Insert lag bolt anchors
[04]
. Then insert lag bolts
[02]
through the washer
[03]
, wall plate
[01]
and into the anchors
[04]
.
CAUTION:
Improper
use
could
reduce
the
holding
power
of
the
lag
bolt.
To
avoid
potential
injuries
or
property
damage:
Ù
Be
sure
the
anchors
[04]
are seated
fl ush
with
the
concrete
surface.
Ù
Tighten
the
lag
bolts
[02]
only
until
the washers
[03]
are
pulled
fi rmly
against
the
wall
plate
[01]
.
Ù
DO NOT
over-tighten
the
lag
bolts
[02]
.
[01]
[02]
[03]
[02]
[03]
[01]
63.5 mm
(2
½
in
.
)