6901-002156 <01>
6
41-61 cm
(16-24 in
.
)
< 16 mm
(5/8 in
.
)
[01]
2 Mount the Wall Plate
Wood stud
5.5 mm
(7/32 in.)
2-1 Locate studs
2-2 Mark the wall
Verify the center of the stud
(s)
using an awl, a thin nail, or an edge
to edge stud finder.
CAUTION:
Avoid potential personal injuries and property
damage!
Ù
Any material covering the wall must not exceed 16 mm (5/8 in.).
Ù
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (1½
x 3½
in.).
For assistance in determining wall plate location, see Height Finder
at sanus.com.
Level the wall plate
[01]
and mark the hole locations.
2-3 Drill pilot holes
2-4 Tighten lag bolts
CAUTION:
Avoid potential injuries or property damage!
Pilot holes MUST be drilled to a depth of 63.5 mm (2½ in.), using a
5.5 mm (7/32 in.) diameter drill bit.
CAUTION:
Improper use could reduce the holding power of
the lag bolt. To avoid potential injuries or property damage:
Ù
DO NOT over-tighten the lag bolts
[02]
.
Ù
Tighten the lag bolts
[02]
only until the washers
[03]
are pulled
firmly against the wall plate
[01]
.
[02]
[03]
[01]
13 mm
(1/2 in.)
63.5 mm
(2
½
in
.
)