(6901-002111 <02>)
7
002534.eps
LF288 / XF288 - Mount to wood stud
89 mm
(3.5 in.)
41 - 61 cm
(16 - 24 in.)
< 16 mm
(5/8 in.)
8.25 cm
(3.25 in.)
82.5 mm
3.25 in.
2
Wall Mounting
Wood stud mounting
Wood stud only
5.5mm
(7/32 in.)
13 mm
(1/2 in.)
[01]
2-1
Locate studs
2-2
Mark the wall
2-3
Drill pilot holes
2-4
Tighten lag bolts
Drill pilot holes as illustrated.
Pilot holes
MUST
be drilled to a depth of 89 mm (3.5 in.), using a 5.5
mm (7/32 in.) diameter drill bit.
CAUTION:
Avoid potential injuries or property damage!
Improper
use
could
reduce
the
holding
power
of
the
lag
bolt.
To
avoid
potential
injuries
or
property
damage:
Ù
DO NOT
over-tighten the lag bolts
[17]
.
Ù
Tighten the lag bolts only until the washers
[16]
are pulled
firmly against the wall plate
[02]
.
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Level the wall plate
[02]
and mark the hole locations.
NOTE:
TV will
shift 82.5 mm (3.5 in.)to the right when in the home position. Consider
this when selecting the location of your wall mount.
Locate studs. Verify the center of the stud(s) using an awl. a thin nail,
or an edge to edge stud finder.
CAUTION:
Avoid potential personal injuries and property
damage!
Ù
Any material covering the wall must not exceed 16 mm (5/8 in.).
Ù
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
(nominal 38 x 89 mm (1.5 x 3.5 in.))
[02]
[02]
[02]
[17]
[16]
