Sanus F256, Инструкция по эксплуатации

Страница: 8 / 14

6902-002023 <00>
8
3
Mount the Wall Plate
Solid concrete or concrete block
3-1
Mark the wall
3-2
Drill pilot holes
3-3
Insert anchors and lag bolts
13 mm
(1/2 in.)
10 mm
(3/8 in.)
75 mm
(3 in.)
Drill pilot holes as illustrated.
CAUTION:
Avoid potential injuries or property damage! :
Ù
Pilot holes MUST be drilled to a depth of 75 mm (3 in.) using a
10 mm (3/8 in.) diameter drill bit.
Ù
Never drill into the mortar between blocks.
Insert lag bolt anchors [06] . Then insert lag bolts [04] through the
wall plate [01] and into the anchors.
CAUTION:
Avoid potential injuries or property damage!
Improper use could reduce the holding power of the lag bolt. To
avoid potential injuries or property damage:
Ù
Be sure the anchors [06]
are seated fl ush with the
concrete surface.
Ù
Tighten the lag bolts [04]
only until the washers
[05] are pulled fi rmly
against the wall plate
[01] .
Ù
DO NOT over-tighten
the lag bolts [04] .
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!
Ù
Mount the wall plate [01] directly onto the concrete surface.
Ù
Minimum solid concrete thickness: 8 in.
Ù
Minimum concrete block size: 8 x 8 x 16 in.
[06]
[06]
[04]
[05]
[01]
[01]