Santec SNC-240, Руководство пользователя

Страница: 18 / 78

18
2. Create a directory named
LANCAM
in the SD card if it does not exist.
3. Copy the file of UPDATE.BIN to the
LANCAM
-directory.
4. If the Network camera is running, please power it off first.
5. Insert the SD CARD into the Network camera.
6. Remove the Ethernet cable from the RJ-45 port and then power on the Network camera.
7. In 5 to 10 seconds, a message reading "UPDATE PROCESSING" will show up on the screen on
a blue background; if not, please check out steps 1 to 6 carefully or else inform your technical
support while ignoring the following steps.
8. DO NOT power off the Network camera while this update process is running until the message
"UPDATE OK RESET PLEASE" appears on the screen; it might take 15 to 30 seconds to
appear.
9. If the message "UPDATE NG RESET PLEASE" appears rather than "UPDATE OK RESET
PLEASE", please write down the error messages shown on the screen and inform your
technical support, while ignoring the following steps.
10. Power off the Network camera when this update process is finished, then remove the SD card
from the Network camera.
11. Reconnect the Ethernet cable to the RJ-45 port if necessary.
12. Power ON the Network camera and it will work normally if the entire update procedure goes
correctly.
13. Verify the version of the system software.
WARNING
:
1. Don ’ t use FAT32 or NTFS or other file formats in step 1.
2. Steps 1 to 3 have to be done on a PC.
3. Make sure the file of UPDATE.BIN is a correct one in step 3, or the Network camera will
not work normally after being updated.
4. If the power of the Network camera is suddenly lost in step 8, please remove the SD card
first and turn on the Network camera next to test its operation. If the Network camera
remains working normally, please go back to step 4; otherwise, please inform your