5) METAL FRAME
4) HDD HANDLE
3) RIGHT SIDE PANEL
1) FRONT PANEL
Notes
Diagrams
2) REAR PANEL
e-SATA Port
(Port Multiplier)
USB 3.0 Port
Fan
Power
Connector
1) Blue - Power on
Orange - Sleep
2) eSATA - Link interface use
3) USB - Link interface use
4) Power button - It needs to be pressed and held for 3 secs to power off. (This
design prevents accidental power off.)
5) Interface button.
6) Synchronization mode button (refer to SYNC LED for details)
7) Smart fan button - auto, manual and fan speed from level 1 to level 3.
8) eSATA - Link interface option.
9) USB - Link interface option.
10) Smart fan automatic mode
11) Smart fan manual mode
12) Fan speed - level 1
13) Fan speed - level 2
14) Fan speed - level 3
15) SYNC LED comes in 3 modes:
Blue - When PC is off, the device goes off in 15 secs.
Orange - When PC is off, the device goes to sleep mode.
Off - synchronization is off.
16 - 19) HDD1 / HDD2 / HDD3 / HDD4
Blue - Active
Purple - Access
2) Operating Environment: Temperature 0 - 50 Celsius / Humidity 0% -
90%.
3) USB port of your PC must support power-off function so that the
device would go to sleeping mode. Setting up motherboard's (power
management) in S3 is strongly recommended. For more details, please
refer to user guide of motherboard BIOS setting.
4) Smart fan is controlled by the built-in thermal sensor, and it comes
with 2 modes (auto / manual) and 3 levels of speed:
Level 1: higher than 55°C
2,500rpm - 3,500rpm
Level 2: 45°C - 54°C
1,800rpm - 2,500rpm
Level 3: below 45°C
1,200rpm - 1,800rpm
5) Press the power button to power on the device or press the button
for 3 seconds to power off the device.
1) To remove the cooling fan, unscrew the four screws located on
each corner of the fan. Unplug the cable connecting the fan to the unit.
