SANNOVER CHAUFFAGE FRANCAIS LEXIA 500W, Руководство по эксплуатации

Страница: 13 / 56

13
1 GENERAL INSTUCTIONS
This appliance is intended for normal household use and not for use in commercial/industrial
environment, in vehicles or on board ships or aircrafts.
The convectors are equipped with a thermostat for setting and automatic maintaining the
desired temperature in the room, with a system of the power step-by-step regulation, with a
limiter of the leaving air (with a self-reset) and with system of the room protection from freezing
(prevents freezing of the hot-water heating system with is not in use).
The convectors are designed for twenty-four-hour operation without constant supervision.
2 TECHNICAL DATA
- Rated supply voltage, V 230±10
- Current frequency, Hz 50±1
- Protected against water projections IP20
- Class of protection from electric current shock II
Other specifications are resulted in table 1
Table 1
Model LEXIA 500W LEXIA 1000W LEXIA 1500W LEXIA 2000W LEXIA 2500W
Rated power, kW 0,5 1,0 1,5 2,0 2,5
Rated current, А 2,1 4,3 6,5 8,7 10,8
Dimensions, mm
(width × depth × height) 400×115×455 490×115×455 600×115×455 740×115×455 890×115×455
3. COMPLETENESS
- Electric convector - 1 pc
- Fixing brackets for wall mounting - 1 set
- Supports - 1 set
- User instruction - 1 copy
- Package - 1 set
4 PREPARATIONS FOR OPERATION
4.1 Unpack the convector. Keep the convector at room temperature for at least one hour
after placing the convector in a room protected from humidity.
4.2 The device must be supplied with 230 V Single-phase 50Hz.
4.3 This equipment was designed to be installed in a residence. Please ask your distributor
before using it for any other purpose.
4.4 Keep the device away from a draft likely to disturb its operation (e.g. under Centralized
Mechanical Ventilation, etc.)
4.3 The convector should be installed according to normal trade practice and in compliance
with legislation in the relevant country (the IEE Wiring Regulations). Check the correspondence
of the mains to the data on the firm label which is on the convector rear wall; check also the
mains and the protection devices ability to with stand the consumption current.
4.4 To stationary installation of convector:
- It is necessary to hold minimum distances from the objects when mounting the convector
as shown in Figure 2, Figure 3 (dimension in cm);