Sankosha LP-690E-V3, Инструкция по эксплуатации

Страница: 23 / 58

21
Let the machine cool completely before changing the cover.
Otherwise it may burn whoever is operating the machine.
Turn the power off before doing this operation.
Use a cover supplied by Sankosha.
Using another company’s cover may give a bad finish. Sankosha takes no responsibility if
you do not use factory original covers & padding.
Cover/Pad Change Instruction
1. How to change the Collar Cover/Pad
①
Push both start buttons without shirt on the machine.
(Figure-1)
② Turn OFF the power supply after setting the air pressure to
0 MPa. (See page 15)
③
Remove the guard plate in front of middle press head.
(Figure-1)
④
Fit the collar silicon sponge and collar spring felt pad 10mm,
then install them to collar cover. (Figure-2)
◎
Pass them through the band.
CAUTION
Collar spring felt pad 10mm
Collar cover
Collar silicone sponge
Uneven side is in
upper position.
Pass them through the band.
Figure-2
Guard plate
Figure-1