Sanitas SWB 20, Инструкция по эксплуатации

Страница: 13 / 52

13
After you have fixed the heated underblanket to the mattress, simply put your bed sheet on top as usual so
that the heated underblanket is between the mattress and the bed sheet.
CAUTION
Make sure that the heated underblanket is spread out entirely flat and that it will not rumple up or
crease when in use.
• To operate the heated underblanket connect the control to the heated
underblanket by plugging in the connector.
• Then plug in the power plug into the mains outlet.
4.3 Switching on
To switch on the heated underblanket, set the slider for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings are illuminated when switched on.
4.4 Setting the temperature
Setting 0: OFF
Setting 1: minimum heat
Setting 2: medium heat
Setting 3: maximum heat
NOTE:
• The fastest way to warm up the heated underblanket is to initially set the highest temperature setting.
• We strongly recommend switching on the heated underblanket approx. 30 minutes before going to
bed and covering it with the quilt to prevent the warmth from escaping.
WARNING
If the heated underblanket is being used over several hours, we recom-
mend that you set the lowest temperature setting on the control to avoid
the body overheating and thereby any potential burns to the skin or heat
stroke.
4.5 Switching off
To switch off the heated underblanket, set the slider for ON/OFF and temperature settings to the “0” (OFF)
position. The temperature settings are then no longer illuminated.
NOTE:
If the heated underblanket is not used for several days, set the slider for ON/OFF and temperature
settings to the “0” (OFF) position and remove the power plug from the socket. Then remove the control
from the heated underblanket by disconnecting it at the connector.
5. Cleaning and maintenance
WARNING
Always remove the power plug from the mains outlet and remove the control from the heated under-
blanket by disconnecting it at the connector. Otherwise there is a risk of electric shock.
CAUTION
The control must never get in contact to water or other liquids. Otherwise the control may be damaged.