Sanitas SBF 72, Инструкция по эксплуатации

Страница: 24 / 64

24
This is necessary if you would like to delete scale users who have been set up incorrectly or are no longer
required, for example.
You must then carry out the actions in chapter 7 (on user assignment) again.
Deleting individual users
Switch on the scale, select the user using the UP button and wait until “ 0.0 kg” appears; press the Unit/
Reset button for 6 seconds until “ ” appears.
Replacing the batteries
Your scale is equipped with a low battery indicator. If you operate the scale with flat batteries, “
Lo
” will
appear on the display and the scale will automatically switch off. In this case, the battery must be replaced
(1 x 3V CR2032).
NOTE:
• Do not use rechargeable batteries.
• Use batteries free from heavy metals.
8. Cleaning and maintenance
The device should be cleaned from time to time.
This should be done using a damp cloth and, if necessary, a small amount of detergent.
IMPORTANT
• Never use abrasive solvents or cleaning products!
• Never submerge the device in water!
• Do not clean the device in a dishwasher!
9. What if there are problems?
These actions are recommended in the following cases:
Display Cause Solution
„ “
Unknown measurement as it
is outside the user assignment
limit or a unique assignment is
not possible.
Select your user by pressing the / but-
tons.
BF- The proportion of fat is outside
the measurable range (less
than 3% or greater than 65%).
Please repeat the measurement barefoot, or
with the soles of the feet lightly dampened
if necessary.
Maximum weight capacity of
180 kg exceeded.
Loads must not exceed 180 kg.
Incorrect weight is dis-
played.
No even, hard surface. Place the scale on an even, hard surface.
Not on carpet.
Incorrect weight is dis-
played.
Not standing still. Stand as still as possible.
Incorrect weight is dis-
played.
Incorrect zero point of scale. Wait until the scale switches itself off. Acti-
vate the scale, wait for “
0.0
kg” to appear
and take the measurement again.
„
BF
“
BIA is not possible. Please repeat the measurement barefoot, or
with the soles of the feet lightly dampened
if necessary.