SaniServ WB Series, Руководство по эксплуатации

Страница: 14 / 28

d. Install the scraper blade holder assemblies onto the
dasher (Fig. 28).
e. Rotate the scraper blade assemblies into position as
shown (Fig. 29).
f. Insert the dasher assembly into the freezing cylinder
as far as possible being careful not to damage the
scraper blades. Damage will occur to the scraper
blades and the dispenser will not operate properly if
the scraper blades are installed facing in a clockwise
direction (Fig. 29).
2. While maintaining force against the dasher, rotate it
slowly until the tongue of the dasher engages the
groove in the drive system at the rear of the cylinder.
The outer most portion of the dasher should be re-
cessed approximately 1/4" to 3/8" inside the freezing
cylinder. No part of the dasher should extend outside
the cylinder. Scraper blades should be visible, ex-
tending approximately 1/8" beyond the dasher. In-
stall the Dasher Support into the front end of the
dasher.
Assembly and Lubrication
(WB7110)
Use a food grade lubricant* ONLY. Haynes Lubri-Film (SaniServ part number 1150) is recommended and is available
from the factory or your local authorized SaniServ dealer or distributor.
Lubrication must be performed daily.
* The SaniServ recommended product is a colorless to white, odorless, tasteless food contact lubricant accepted by the
United States Food and Drug Administration (FDA) with a USDA rating of H1 and certified for food contact by NSF
International. Its useful temperature range is -15
°
F - 210
°
F (-26
°
C - 99
°
C) with a melt point of 93
°
C using ASTM D566
and a Saybolt viscosity of 55 at 210 ° F (99 ° C) when measured using ASTM D445
Fig. 29
Dasher Installation
PAGE 10
ASSEMBLY and LUBRICATION
Fig. 27
Dasher Support and Dasher
Lubrication
Fig. 28
Dasher Assembly
1. Lubricate and assemble the dasher assembly in
the following manner:
a. Apply a 1/4" bead of lubricant to the shoulder
of the dasher where the white plastic portion of
the assembled rear seal contacts the shaft
(Fig. 27).
b. Lubricate the front dasher support as shown.
c. Assemble and install the rear seal with the rub-
ber portion toward the rear of the dasher (Fig.
27).
DO NOT LUBRICATE THE RUBBER PORTION
OF THE REAR SEAL.
CAUTION