Sanipex BAGNODESIGN BDR-HPA Series, Руководство по установке

Страница: 3 / 19

Place your mirror face down on a flat
surface. Clean the mirror reverse to
remove dirt. Carefully mark the back of
the mirror to indicate where the pad is to
be fitted. Remove the safety foil from
the heater pad reverse. Place the pad
sticky side down onto the back of the
mirror, in the area you wish to place,
ensuring there are no air bubbles.
Connect three wires:
Neutral, Phase & Ground.
The mirror should be carefully installed
and a qualified electrician should carry
out the electrical connection.
Gently lift the mirror & mount the
mirror onto the mounting brackets.
Installation Complete.
HEATER PAD
Reverse of Mirror
Back of the
heated pad
NOTE: Never cut th e heated pad to make it fit. Make sure there are no air
bubbles. When using two heated pad never overlapped.