Sanipex BAGNO DESIGN BDB-SOK-860-WS, Руководство по установке

Страница: 5 / 8

Installation
IMPORTANT! Install this product according to the installation guide. Spout must
provide a minimum of 60mm reach for adequate clearance into bath. Our
products must be installed by certified professional only and according to our
installation guide as well as federal, provincial/state and local building codes and
regulations.
• Installation Requirements
Please read the instructions carefully and follow the specified guidelines so as to
avoid any damage to the fixture.
1. The owner/user of the product must keep this information for future reference.
2. Consult local building codes to make sure the installation complies with
standards.
3. Remove the unit from its packaging. Before disposing of it, inspect the unit to
make sure it is in good shape. Should inspection reveal any damage or defect in
the finish, contact your distributor. The warranty does not cover damages or
defects in the finish once it has been installed. The Manufacturer’s responsibility
for shipping damages ceases upon delivery of the product in good order to the
carrier. All complaints regarding damage due to transport must be made.
4. Place the unit in the bathroom before you start working. Conserve all nuts and
bolts.
5. To protect the unit during installation, we recommend that you lay a piece of
cardboard on the bottom.
6. If the unit is covered with polyethylene protective film, do not remove until
installation is complete to grant maximum protection. However, remove the
film where any two surfaces will be in permanent contact.
7. Verify that all dimensions on the plan are the same as the ones of the unit.
• Installation Notes