SANEI ELECTRIC Printy 3 BL-80RS II, Инструкция по эксплуатации

Страница: 19 / 29

16
◇
Selecting paper
Paper selection = Normal paper
：
Normal paper selected.
Paper selection = Reprint paper
：
Reprint paper selected.
◇
Setting the Upright/Inverted printing
Upright/inverted = Upright printing
：
Upright printing
Upright/inverted = Inverted printing
：
Inverted printing
◇
Setting Auto Power OFF
Auto power off = Available (ON)
：
Auto power off enabled (90 min. at default)
Auto power off = Invalidity (OFF)
：
Auto power off disabled
Note: You can set a time of 1 to 255 minutes in units of minutes (using a
command.) For information on how to set it, please check the Technical
Manual.
◇
Setting the battery mode
Battery mode = Invalidity (OFF)
：
Battery mode disabled
Battery mode = Available (ON)
：
Battery mode enabled
Note: When the battery mode is enabled, the number of dynamic partitions is
automatically changed according to the voltage value (The number of dots
for dynamic partition is changed. The lower the voltage is, the smaller the
number of dots is.) The printing partition change command is ignored.
When using the battery, it is recommended to enable the mode.
When the following message appears, the operation setting mode is retained.
Data Keeping, Setting mode END !!
Finally, test printing is performed and data input is allowed.
Note: The setting using a control code, ESC+"S" + romsw2 is possible.
(Others than Auto Power OFF, battery mode.)
Also note: To return the mode to the initial state it was at shipment, turn on the
power while holding down the SELECT switch and the FEED switch.