SANEI ELECTRIC Printy 3 BL-80RS II, Инструкция по эксплуатации

Страница: 17 / 29

14
8. Printer Operation
8-1 Setting the operating functions
Use the FEED and SELECT switches to set the printer operating functions.
The following functions have been initially set at the factory. After you perform
setting, the settings are retained even after you turn off the power.
(1) While holding down the FEED switch, turning on the power prints out the
current printer setting mode and then it stops.
BL-80RII/RSII [VX.XX] XXXX/XX/XX
SANEI ELECTRIC INC.
******************************
Data input = Serial
International char
= Japan
Print mode = Graphic
Character set
= 24dot ANK Gothic type
Select switch = Available (ON)
Baud rate
= 9600bps
Bit length = 8 bits
Parity
= Non
Data control = SBUSY
Paper selection = Normal paper
Upright/inverted = Upright printing
Auto power off =Available (ON)
Battery mode = Invalidity (OFF)
Shr=0117 temp=029 shvp=740
Push FEED button => END
Push SEL
button => Setting mode
:
Version No. Year/month/day
: International character: Japanese
:
Character/inter-line space setting (interval 0 dot)
: 24-dot system, Gothic-type character
: Whether SELECT switch is used or not
: Baud rate: 9600 bps
: Data bit length: 8 bits
: Parity present: No
: Control system: SBUSY
: Paper selection: Normal paper
: Upright printing set
: Auto power off selected
: Battery mode
: Internal status
:
Pressing the FEED switch stops operation after test printing.
: Pressing the SELECT switch goes to the
operation setting mode.
(2) At this time, choose whether you will enter the operation setting mode or to begin
test printing. Pressing the FEED switch does not start the operation setting mode
but only performs test printing.
Pressing the SELECT switch establishes the operation setting mode as follows:
Setting mode
Push FEED button => Go to next
：
Pressing the FEED switch goes to the
next setting.
Push SEL button => Condition change
：
Pressing the SELECT switch allows you
to change the functions.