3.5"-eIO-GPA - User Guide, Rev. 1.0
// 13
1
Hole for Securing 3.5’’ Single Board Computer
2 Hole for Securing 3.5’’-eIO-GPA
3 Hole for Securing 3.5’’ Single Board Computer & 3.5’’-eIO-GPA
To get the 3.5’’-eIO-GPA running follow these steps. Depending on the ordered configuration, the board may be pre-
installed on the applicable Kontron’s 3.5’’ single board computer. If the board shipped from KONTRON already has
been installed on the 3.5’’ single board computer, then skip the relevant steps below or uninstall them first for
installation into the chassis.
1.
Secure the fixing bolts onto the SBC
Place the applicable single board computer onto the chassis by aligning the screw holes on the single board
computer (Figure 2, pos. 1 & 2) with the screw holes on the chassis. Secure the single board computer with the
three supplied fixing blots (Figure 1, pos. 1) via three corresponding holes (Figure 2, pos. 2 & 3) and two additional
screws via the other holes.
Figure 3: Secure Fixing Bolts Onto SBC
2.
Secure the 3.5’’-eIO-GPA onto to the SBC
Insert the 3.5‘‘-eIO-GPA onto the single board computer by connecting the board-to-board connectors of two
boards. Concurrently align the screws holes on the 3.5‘‘-eIO-GPA with the screw holes on the fixing bolts (Figure 1,
pos. 1) secured on the single board computer. Secure the 3.5‘‘-eIO-GPA with three supplied screws (Figure 1, pos.
2) via the three corresponding holes.
Figure 4: Secure Fixing Bolts Onto SBC
