![S&T Kontron 3.5](http://html1.mh-extra.com/html/sandt/kontron-3-5-eio-gpa/kontron-3-5-eio-gpa_user-manual_3080116012.webp)
3.5"-eIO-GPA - User Guide, Rev. 1.0
// 12
2/
Installation Procedures
2.1.
Installing the Board
ESD Sensitive Device!
Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry.
Wear ESD-protective clothing and shoes
Wear an ESD-preventive wrist strap attached to a good earth ground
Check the resistance value of the wrist strap periodically (1 MΩ to 10 MΩ)
Transport and store the board in its antistatic bag
Handle the board at an approved ESD workstation
Handle the board only by the edges
3.5’’-eIO-GPA is supplied with three fixing bolts with M3 x 4 mm screw (Figure 1, pos. 1) and three screws (Figure 1,
pos. 2).
Figure 1: Accessories of 3.5’’-eIO-GPA
1
Fixing Bolt
2 Screw
To install 3.5’’-eIO-GPA, the chassis must have the screw hole pattern shown as Figure 2.
Figure 2: Screw Hole Pattern for Install 3.5’’-eIO-GPA & Applicable 3.5’’ SBC
unit: mm
1
1
1
2
2
2
1
1
2
3
3