Sandstrom S200DT10, Инструкция по эксплуатации

Страница: 48 / 56

Room
M
onit
or
A
nsw
er
M
achine
Te
xt
M
essag
ing
U
sing
Additional
Handsets
Help
GB-48
HELP
Phone does not work
• Have you installed the batteries correctly?
• Check that the mains power is correctly connected.
No dial tone
• Is the telephone cord of the base plugged into the phone socket?
• Check that the mains power is correctly connected to the base and to the handset charger(s).
• Only use the telephone cord supplied with the phone.
Cannot dial out or receive calls
• Check that the mains power is correctly connected.
• The batteries may need recharging.
• Has there been a power cut? If so, place the handset back on the base for 10 seconds and try again.
If it still does not work disconnect the batteries and mains power for 10 minutes, then reconnect and
try again. You have a dial tone, but the phone will not dial out
• You may need to change the dial mode from tone to pulse.
• If you are connected to a switchboard, check whether you need to dial an access code.
Handset does not ring
• The ringer volume may be switched off.
• Check that the mains power is correctly connected.
• Check that the line cord is connected.
• Make sure the handset is registered to the base.
No display
• The batteries may be flat, dead or incorrectly inserted. Recharge or replace the batteries.
icon flashes
• Is the handset registered correctly to the base.
• Check that the mains power is correctly connected.
• Check that the handset is within range of the base.
• The batteries are low, place the handset on the base/charger to recharge.
icon not scrolling
• Try cleaning the charging contacts.
• Check that the mains power is correctly connected.
You hear the busy tone when you press the button�
• Make sure the handset is in range of the base.
• Another handset registered to your unit base may be on the line.
Answer machine does not record any messages
• The memory may be full. Play and delete old messages.
Answer machine messages have the wrong date and time
• Have you set the date and time?
S100DT10_100722.indd 48 7/22/10 10:36 AM