Sandel ST3400H HeliTAWS, Руководство по установке

Страница: 42 / 112

5 SETUP PROCEDURES
5.1 General
Setup procedures for the ST3400H are described along with the Maintenance menu below. The
Maintenance Menu is accessed and addressed through the use of pushbuttons and the
BRT/MINs knob. No external connector programming is required.
5.2 Accessing Maintenance Menus
To access the Maintenance Menus perform the following operations:
•
Prior to applying power to the ST3400H, depress and hold the [MUTE] and [SENS]
pushbuttons, then apply power to the unit. Continue to hold until the first maintenance
menu appears.
•
Once the Maintenance Menu is entered, press the [NEXT] or [PREV] soft-keys to cycle
the MAINTENANCE MENU pages. To jump to a specific page, from the INDEX page,
press the [UP] or [DOWN] soft-keys or rotate the BRT/MINS knob to move the cursor.
Press the [SELECT] soft-key to jump to that page. On some menus additional soft-key
legends will appear as prompts.
•
Escape the maintenance menus by pressing and holding the “M” button. This will allow
normal operation of the unit to test the effects of the settings. Re-enter the maintenance
pages by pressing and holding the “M” button.
To disable the maintenance menu operation, power down and restart normally. All configured
items are stored in non-volatile memory.
5.3 Equipment/Configuration Selections
The choices of compatible equipment contained in the ST3400H menus are listed in section 8.
For types not listed, consult the factory.
5.4 Configuration Module – (Reserved for future use)
The Configuration Module (CM) stores installation configurations. The physical Configuration
Module is directly mounted to the rear of the instrument. Configuration module can be used
when replacing an existing ST3400H. Data stored in the configuration module can be copied
directly to the replacement unit. It is advisable to leave the configuration module plugged into
the unit to avoid misplacing it.
5.5 Configuration Module Status Page - (Reserved for future use)
“CONFIG MODULE STATUS” page may appear during initial turn on and programming of
a unit. This page will only appear again if there is a mismatch between the configuration
information saved in the Configuration Module and the ST3400H. The mismatch identified
82046-IM-K ST3400H INSTALLATION MANUAL Page 5-1