Sandel ST3400H HeliTAWS, Руководство по установке

Страница: 22 / 112

Recommended Crimp Tools
High Density
22-28 AWG
Standard Density
20-24 AWG
Manufacturer
Hand
Crimping Tool Positioner
Insertion/
Extraction
Tool
Positioner
Insertion/
Extraction
Tool
Military P/N M22520/2-01 M22520/2-09 M81969/1-04 M22520/2-08 M81969/1-02
Positronic 9507 9502-3 M81969/1-04 9502-5 M81969/1-02
ITT Cannon 995-0001-584 995-0001-739 N/A 995-0001-604 980-2000-426
AMP 601966-1 601966-6 91067-1 601966-5 91067-2
Daniels AFM8 K42 M24308/18-1 K13-1 M24308/1-02
Astro 615717 615725 M81969/1-02 615724 M81969/1-02
2.4 Installation
Using the information in section 2.3 and section 4, install the ST3400H.
2.5 Post Installation Procedures
Post installation procedures are summarized as follows:
•
Prior to power-up, review correct wiring by using industry accepted ohmmeter and
voltage checks. Pay particular attention to presence of +28V on only the correct pins; 0
ohm resistance check on ground pins to airframe ground; and presence of inverter 400Hz
(if used) only on the appropriate pins.
•
Review any special items particular to the subject helicopter installation.
•
Power up the ST3400H in maintenance mode (reference to Section 5) and sequentially
access each maintenance page to select the installed equipment (reference to Section 6).
•
Check proper cooling airflow as follows:
•
Allow the unit to operate for 30 minutes.
•
Check the internal temperature readout on the appropriate maintenance page for an
approximate temperature rise (approximately 10°C or 18°F over ambient).
•
Perform Ground Test procedures (Checkout) specified in Section 7.
•
Complete all required installation documentation. Possible documents may include:
a. Log book entries
b. FAA Form 337
c. RFMS
d. Weight and balance update
e. Electrical load analysis
82046-IM-K ST3400H INSTALLATION MANUAL Page 2-4