- 5 -
4. Remove lock cover
Remove the lock cover(16) from the adapter(17).
5. Connection
Connect flexible tube(14) from the faucet with adapter(17). Then, please clip them
With fastener clip(15) until there make a "click sound". After making sure the
connection is done in perfect, please attach the lock cover(16) onto a fastener clip(15).
6. Work testing
Please go to "Flushing instruction" section before starting to use faucet.
CAUTION!
Please pay attention to the following points when installing the faucet.
* Install the supply tube to the cold and the hot supply side properly. Don’t tangle
the hose when installing because the connection will become loose when the
strong water pressure is added.
* Keep enough distance between the hoses. Without the distance, the hose will rub
each other and it will cause damage to the hose.
* When bending the hose, keep the radius more than 50mm. Excessive bending
will cause damage to the hose.
* When installing the faucet, do not excessively bend the ending part of the hose.
* "C" mark on the supply tube stands for cold water supply use.
* "H" mark on the supply tube stands for hot water supply use.
- 4 -
2. Install faucet
Install the faucet body on the kitchen sink.The front side of the spout should
face you.Then, make tightening the lock nut(13).(counterclockwise)
Please don’t forget to put a seat packing(10), rubber packing(11), and
metal washer(12) between unit body(9) and lock nut(13).
MAX
1-1/5"(30mm)
18
17
16
14
15
12
11
9
10
13
Sink hole dia
Between 1-2/5"(36mm)
to 1-1/2"(38mm)
I N S T A L L F A U C E T
1
2
4
5
3
16
3. Install "quick fastener" adapter
Please install the adapters(17) onto the each stop valves(not supplied).
Please don’t forget packing(18) between angle stop valve and adapter(17).
1. Measurement
Be sure that mounting space is clean and dry.
Please make sure the diameter of the mounting hole before installation.
(Please pay attention not to bend the hose tube excessively.)
Flex Tube
Rubber Packing
28
18
To extend both cold water and hot water supply hoses.
In case the supply hoses from the faucet cannot
reach to the stop valves for connection, please use
the fastener adaptor (male thread type) to extend
the supply hose from the stop valves. (Flex supply
tube not supplied.)
Thread Size
1/2-14 NPSM
NOTE
:
Thread Size 1/2-14 NPSM
