SAMUEL JACKSON Argus, Инструкция по установке и руководство по ресурсам

Страница: 18 / 40

INSTALLATION
Argus Installation and Resource Guide 16
Horn Strobe Terminal block
2.6 WIRING HORN/STROBE
Figure: Horn/Strobe circuit board wiring to Alarm/Monitor terminal block
Wiring the Horn/Strobe the Alarm/Monitor card is very simple. There are four wires:
three black wires and one green/yellow grounding wire. Wires 2 and 3 are connected to
the horn, and wires 1 and Ground are connected to the strobe. The wiring inside the
Horn/Strobe is default from the factory. For setup, all that needs to be wired is the
Alarm/Monitor terminal.
Note: The buzzer on the door is also wired into terminals 8 and 9, but this is intentional.
Tip: Alarm/monitor cards come with a resistor attached between terminals 4 and 5,
which work to “fool” the system into thinking a horn is attached. If for some reason the
horn is disconnected, it is useful to keep the resistor. This will prevent the trouble light
from coming on.
INSTALLATION
Argus Installation and Resource Guide 16
2.6 WIRING HORN/STROBE
Figure: Horn/Strobe circuit board wiring to Alarm/Monitor terminal block
Wiring the Horn/Strobe the Alarm/Monitor card is very simple. There are four wires:
three black wires and one green/yellow grounding wire. Wires 2 and 3 are connected to
the horn, and wires 1 and Ground are connected to the strobe
. The wiring inside the
Horn/Strobe is default from the factory. For setup, all that needs to be wired is the
Alarm/Monitor terminal.
Note: The buzzer on the door is also wired into terminals 8 and 9, but this is
intentional.
Tip: Alarm/monitor cards come with a resistor attached between terminals 4 and 5,
which work to “fool” the system into thinking a horn is attached. If for some reason the
horn is disconnected, it is useful to keep the resistor. This will prevent the trouble light
from coming on.
1 2 3 4 5 6 7 8 9
HHHHHHHHHHHHHHHGG
Wire 2 Wire 3 Wire 1 Ground
Wire 2
Wire 3 Wire 1
Ground
HHHHHHHHHHHHHHHGG