- 19 -
3) Water Supply Function
①
When selecting Wash
-. Water is supplied through cold water + hot water(option) valves to the frequency level of the
wash set up for each course.
(The hot-water valve does not operate when the temperature is set to below 60
℃
.)
If the wash temperature is set to over 40
℃
for each course, it supplies water to
the set-up level and performs a Wetting Cycle and then starts the Heating cycle.
-. When the water level decreases during the Wetting Cycle after the end of the water
supply, it supplies water using a supplementary water-supply function.
(Except for the Wool and Lingerie courses)
-. Conditions of the Hot-Water Supply (Option)
●
For a temperature setup of over 60
℃
the cold/hot water valves operate at the same time.
●
Both cold and hot water are used for steering the water level and as supplementary water.
4) Drying Function
① When the drying function starts, the heater, fan/M, drying water supply and drainage motor
perform their operations, running the washing motor using a stream of water.
② The drying cycle is processed in the order below:
- Detection of Drying Amount
- Primary Drying: Operates the 2000W heater (2 1000W heaters)
- Secondary Drying: Operates the 1000W heater
- Ventilation: When the drying cycle is done with dryness sensing, the washer turns off
the heater and only runs the fan motor, lowering the temperature inside the drum.
All cycles are completed when the temperature of the internal sensor (air sensing) is
below 70℃ (60℃ inside of the drum).
③ Dedicated Drying Course Algorithm
a. When selecting Dedicated Drying, the drying cycle starts to operate and completes
its operation once cooling has ended.
b. During the initial drying operation, if the water level goes over a certain level,
pre-heating is added before dehydrating. When selecting a drying time, the washer
enters the drying cycle directly without sensing the dry amount. When select a
drying option, drying is performed after twice sensing the dry amount.
c. If pre-heating is added to dehydrating, the display time increases by 17 minutes.
d. Selecting the Drying Time does not require detecting the drying amount while the
Drying Option does require detecting the amount twice when the remaining time is
displayed.
④ Algorithm when adding Drying to normal courses
a. The drying feature can be added to courses other than wool, lingerie, quilt and
drum washing.
b. When drying is added, the last dehydrating cycle is converted from normal to pre-heat.
When all normal cycles are done before the drying process starts, the washer senses
the drying amount to reset the drying time and displays the remaining time.
(For Drying added by the Drying Option)
