© SAMSUNG Telecommunications America
3
b.
Set up WBS24s (APs):
i.
Use volume key to scroll until CWBS1 appear. The cursor must be under the first
character to have CWBS to show up. Use left soft key to move cursor to the 1
st
character position.
ii.
Set IP addresses; repeat these steps for all APs.
[CWBS1 : IP ADDR ]
[165.213. 97. 11 ]
iii.
Set Gateway.
[CWBS1 : GATEWAY ]
[165.213. 97. 1 ]
iv.
Set Net mask.
[CWBS1 : NET MASK]
[255.255.255. 0 ]
v.
Set RF channel; use different channel for each AP.
[CWBS1 : RF CHAN ]
[USE CH 1:01 ]
Note: If RF Channel shows NONE or 0, AP will keep rebooting.
vi.
Set TX power for individual AP; level 4 is max.
[CWBS1 : TX POWER]
[LEVEL 4 ]
Note: After the above setting, access point will start powering up. It will take about 1
minute to be operational. In idle state, the LED PWR, WLI, and WLAN will stay on and
LD1 and LD2 are off. You MUST wait for the AP in idle state before starting
handset registration.
6.
MMC 848
a.
Set handset IP address for each handset.
[IP:001 USED: ]
[165.213. 97.101 ]
7.
Handset Registration
a.
Need to un-register first, if handsets have previous registration data.
i.
Press <menu>, <6>, <3>, <password> (default 1234), <1> to un-register.
b.
Enter the following info to register the handset:
i.
Press <Menu>.
ii.
Select <6> for System.
iii.
Select <1> for Registration.
iv.
Select <1> for System 1.
Home Page
Table of Contents