7
ENGLISH
3.
Use two or more screws to fix the back cover to the wall. Connect the power cables (V1, V2) and
communication cables (F1, F2) to the terminals on the back of the front cover while adjusting to a suitable
length.
4.
When connecting the power cables to V1 and V2, fasten the PCB terminal screws (CN5) to a torque of
6 N·cm or less.
Screw size: M3 x 6
F1
V1 V2
F2
F3 F4
• You can connect up to 16 indoor units to a Wi-Fi Kit.
F1
V1 V2
F2
F3 F4
ⓑ
ⓔ
ⓕ
ⓐ
ⓓ
ⓒ
10 and
over
10 and over
50 and over
10 and over
Screw
holes
※
Be sure to secure space of at least
10 mm (up/right/left) and 50 mm
(down) around the back cover
before fixing the back cover on
the wall.
※
Fix the screws to the
screw holes.
※
Do not over-tighten the PCB
terminal.
V1 V2 F1 F2
Wi-Fi Kit
PCB port
Indoor unit
Unit: mm
Back over
Item
Contents
Item
Contents
ⓐ
Power/communication terminals
ⓓ
LED
ⓑ
Tracking/Reset button
ⓔ
Network PBA
ⓒ
Micro SD card slot
ⓕ
Interface module PBA
5. Assemble the Wi-Fi Kit again.
•
Insert the front cover to the upper grooves as shown in the figure. After assembly,
make sure that there is no gap between the covers.
NOTE
NOTE
SOL OCF Wi-Fi KIT 구통신 유럽향 IBIM_EN_DB68-08417A-00_.indd 7
2019-06-21 오후 4:11:42