Samsung WF419AAU/XAA, Руководство по устранению неисправностей

Страница: 7 / 7

# tsWF419 RevE 03/21/2011
7
Pre Wash
Main Wash
Softener
Bleach
Path #2
Path #1
Path #3
Path #4
Path #5
V#1 V#2 V#3 V#4 V#5
MAIN(H) PRE WASH BLEACH MAIN(C) STEAM
Water valve connections for the Detergent Drawer Items Packed With Washer
BOLT-SPANER (10-13mm Wrench) DC60-40146A
ASSY HOSE WATER DC97-15691A and DC97-15692A
MANUAL-BOOK DC68-02535A
CAP-FIXER DC67-00307A HOSE-HANGER DC62-10278A
When using non-HE
detergents, or using
too much detergent
for the water hard-
ness and soil level of
the clothing, over
sudsing will occur.
When this happens
there will be leaks out
of the detergent
drawer and door.
Please advise con-
sumer of proper de-
tergent usage.
Selecting Language
1. The ―Select the Language‖ message appears.
2. Turn the Jog Dial to select language
3. Press Signal button to select
It is normal for a small amount of water
remaining in Detergent Drawer after it
completes washing. Bleach is usually
flushed out into the tub at the beginning
of the washing. Also, its compartment is
washed again during the following rinse
cycle, removing any remnants.
Stacking Kit : (Model No : SK-3A1/XAA, SK-4A/XAA, SK-5A/XAA)
Samsung washers and dryers can be stacked to maximize usable space.
An optional stacking kit is available for purchase from your Samsung retailer
Location considerations
Do not install your washer in
areas where water may
freeze, since your washer
will always maintain some
water in its water valve,
pump, and hose areas. This
can cause damage the
belts, the pump, hoses and
other components.
Operat-
ing temperature should be
above 60°F/16°C.
NOTICE
The unit sometimes will pause during Sanitize, or Pure Cycle, wash modes and appear not to be functional. The Sani-
tize and Pure Cycle wash cycles have target temperatures to assure washer performance. If the water temperature
doesn't meet the target temperature during the wash cycle, the washer will automatically add extra time to allow the
heater to bring the water up to the programmed, or target temperature. In this stage, the displayed time will pause and
hold until the heating operation has been completed. It is at this point that the customer may feel that operation has
stopped. (The maximum added programmed time is 30 minutes)