English 27
Ins
tallation
STEP 6
Running a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1.
Load about 6 pounds of laundry into the tub.
2.
Press
Power
to turn on your washer.
3.
Select
Rinse+Spin
by press the
Cycle Selector
.
4.
Press and hold
Start/Pause
to start the test cycle.
5.
The washer should not rock or vibrate excessively when water is supplied or when
washing or spinning, and should drain well during the spin cycle.
NOTE
If water leaks while water is being supplied or drained, check the water connections. Refer to
the “
STEP 2 Connecting the water supply hose
” section on page
21
for instructions.
NOTE
If the washer rocks and vibrates excessively, level your washer again. Refer to the “
STEP
4 Leveling your washer
” section on page
25
for instructions.
STEP 7
Calibration Mode
Your Samsung washer detects the laundry weight automatically.
For more accurate weight detection, please run Calibration Mode after the installation.
To run Calibration Mode, follow these steps:
1.
Remove laundry or any contents in the machine.
2.
Press and hold
Temp.
and
Delay End
simultaneously for at least 3 seconds when the
power is turned on.
3.
Press and hold
Start/Pause
to activate Calibration Mode.
4.
The pulsator rotates clockwise and counterclockwise approximately 1 minute.
5.
When Calibration Mode is finished, “
0
” appears on the display, and the washer
automatically turns off. The washer is now ready for use.
WA8700K_WA50K-03647A-01_EN.indd 27
2016/1/13 16:49:57
Содержание WA50K8600A Series
Страница 1: ...Washer User manual WA50K8600A SSEC SEC WA8700K_WA50K 03647A 01_EN indd 1 2016 1 13 16 49 50 ...
Страница 69: ...Memo WA8700K_WA50K 03647A 01_EN indd 69 2016 1 13 16 50 09 ...
Страница 71: ...Lave linge Manuel d utilisation WA50K8600A SSEC SEC WA8700K_WA50K 03647A 01_CFR indd 1 2016 1 13 16 58 31 ...
Страница 141: ...Lavadora Manual del usuario WA50K8600A SSEC SEC WA8700K_WA50K 03647A 01_MES indd 1 2016 1 13 17 05 12 ...