installation & maintenance
_13
ASSEMBLING THE RAT PROTECTION PANEL
1.
It is easier engaging the shutter when the set is
lifted up a little, as shown in the figure below.
2.
Insert the shutter completely through the
engagement hole from the back.
HOW TO PUT THE DETERGENT IN
1.
Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box.
2.
Put in one-time amount of detergent evenly so the detergent may not brim over
the box.
HOW TO ADD THE FABRIC SOFTENER
Slide and open the cover in the direction of the arrow, insert the rinse detergent, and slide and close it in the
reverse direction.
•
When a proper amount (one time does) of fabric softener is stored in the
softener inlet, it is automatically put in at the last rinsing cycle.
•
Do not use detergent, bleach or starch into the Softener Inlet.
•
Using too much softener may produce unsatisfactory results.
•
Do not open the lid during the Spin Dry cycle. If added too early, its
effectiveness will decrease.
•
Do not leave the softener into the Softener Dispenser for a long time.
Because softner became stiff.
WATER SUPPLY CONNECTOR FILTER
1.
Pull out the filter and
wash well.
2.
Pull in the filter and connect the
hose to the inlet water valve tightly.
3.
Check if there is a leakage. Note
to tighten up the connector.
CLEANING THE FILTER
1.
Push the upper part of the Magic filter and pull in.
2.
Open the cover as shown in the figure.
3.
Clean the Magic filter.
4.
Close the cover and insert the lower part of the
filter in the basket first and then push the filter
with “click” sound.
Rear-side
WA10V5-02596H_EN.indd 13
2009-03-20 ¿ÀÈÄ 2:38:46
