Samsung SyncMaster P50FP, Руководство пользователя

Страница: 81 / 102

Troubleshooting
Self-Test Feature Check
Note
Check the following items yourself before calling for assistance. Contact a Service Center for
problems that you cannot solve by yourself.
Self-Test Feature Check
1. Turn off both your computer and the PDP Display.
2. Unplug the video cable from the back of the computer.
3. Turn on the PDP Display.
The figure shown below ("Check Signal Cable") appears on a black background when
the PDP Display is working normally even though no video signal is detected: While in
the Self-Test mode, the LED power indicator remains green and the figure moves around
on the screen.
4. Turn off your PDP Display and reconnect the video cable; then turn on both your com-
puter and the PDP Display
If your PDP Display screen remains blank after using the previous procedure, check your
video controller and computer system; your PDP Display is functioning properly.
Warning Messages
You can even view the screen at a resolution of 1360(1920) x 768(1080). However, you will
receive the following message for a minute; You can choose to change the screen resolution
or stay in the current mode during that time. And if the resolution is more than 85Hz, you will
see the black screen because the PDP Display does not support over 85Hz.
Note
Refer to Specifications > Preset Timing Modes for the resolutions or frequencies supported
by the PDP Display.
Maintenance and Cleaning
1) Maintaining the PDP Display Case.
Clean with a soft cloth after disconnecting the power cord.