INSTALLATION
Leave some space
Space at last 15cm between the washer
and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2˚)
Never install the washer near water.
Do not place the washer in steamy rooms or
where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
Avoid direct sunlight or heating devices.
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters, boilers,etc.
Do not place under direct sunlight.
CLEANING THE MACHINE
7
ENVIRONMENT
1. CLEANING THE FILTER
Pull the overflow filter out and take up the filter
by removing 3 screws as shown in figure.
Wash the filter and washing tub.
2. CLEANING THE WASHER BODY
Wipe off strains on the cabinet and
operation panel with soft cloth.
Do not use benzene,thinners,cleanser,
or wax, nor scrub the washer with a brush.
Painted surfaces or plastic parts will be
damaged.
70~80cm
1. Place a rag under the washer filter
not to wet the floor.
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and rotate
the filter clockwise until it
locks in position.
Rag
Close
Open
Filter
HOW TO CLEAN THE FILTER
(In case drain pump)
Install the drain hose about
70~80cm above the ground
for pump model.
SWT13S2-66%-01600B 9/10/02 2:48 PM Page 8
