COLOR DOME CAMERA
User Guide
10
COLOR DOME CAMERA
User Guide
11
Installation
Installation
Pan Bracket :
Control panning angle of camera.
Rotate Body :
Control rotating angle of camera.
x3.6 Vari-focal Lens Module :
2.8 ~ 10.0mm(F1.2).
Video Output Terminal to Monitor
Function Setup switch :
Display the menu on the screen and move the cursor to four
directions to confirm status or after changing a selected item.
UTP Cable :
For supplying AC 24V / AC28V power to the camera and transmitting video
signals.
Video Output Jack :
Video signals are output through this port. Connect this port to the
Video IN port of a monitor.
Power input terminal :
If the UTP cable cannot be connected for power supply (distance
over 300m(1000ft), for example), this cable is used instead for connecting DC 12V / AC
24V power to the camera.
Dome Cover
Shield Case
Overview
1) Separate the dome cover by rotating anti-clockwise.
2) Separate the shield case by pulling from the camera body.
• The installation should be done by qualified service personnel or sytem installers.
• If the ceiling material is not strong enough to hold the installation screws, the camera
may fall off. Reinforce the ceiling as needed.
Notes
* To install the dome cover on the camera
body, turn the latches in locking direction
as shown in the figure 1.
Locking direction
(Clockwise)
Latch
Locking direction
[Figure 1]
Main Body
(Camera)
Shield Case
Dome cover
Unlocking direction
(Anti-clockwise)
