6_
assembling the cleaner
ATTACH HANDLE TO VACUUM
ATTACH VACUUM HOSE AND TOOLS
1. Stand the vacuum upright and slide the base of the
handle firmly into the grooves at the top of the vacuum
body.
2. Check to be sure the handle is fitted to the vacuum
body. If there is a gap, continue to push firmly until the
handle is flush.
3. Insert the 25mm screws provided from the bag with
an accessory holder into the existing holes each side.
Tighten securely with a screwdriver.
1. Align tabs on end of hose with slots in edge of hose
attachment hole on back of vacuum. Push hose
end in and turn clockwise to lock into place.
2. Slide the end of the hose wand onto the hose wand
base.
Note :
The vacuum will not operate properly unless
the hose wand is firmly attached.
3. Snap the hose into the hose clip on the back of the
vacuum handle.
4. Attach the accessory holder by lining up the tab on
the base with the corresponding notch on the back
of the vacuum and insert a 16mm screw provided
from the bag with an accessory holder into the
existing hole. Tighten securely with a screwdriver.
5. Slide the extension wand and the crevice tool
together into the accessory holder right side.
6. Attach the combination tool into the accessory
holder left side as shown.
7. Store Petz Turbo Brush (or Mini Turbo Brush) on
the front of the handle by lining up the Petz Turbo
Brush (or Mini Turbo Brush) base with the base of
the holder then push back to snap into place.
Accessory Holder
16mm screw (1EA) to
assemble Accessory Holder
25mm screws
(2EA) to assemble
Handle
2
1
1
4
7
3
5
6
2
✽
Option
assembling the cleaner
