ENGLISH-
25
troubleshooting
Symptom
checklist
the PoWeRbot is not
working at all.
▶
Check if the emergency switch is on.
▶
Check if all the icons are displayed on display panel.
▶
Check if the battery of POWERbot is depleted.
-
When "Lo" is displayed, carry POWERbot to the charger to charge it.
▶
Replace the batteries (AAA type) when the remote controller is not
working.
the PoWeRbot is stopped
during cleaning process.
▶
When "Lo" is displayed on the display panel, carry POWERbot to the
charger to charge it.
▶
When POWERbot is stuck by the obstacles such as cord, threshold etc,
pick it up to remove it from the obstacle.
-
If any fabrics or strings are caught in the drive wheel, turn off the
emergency switch and remove the fabrics or strings before using it
again.
Suction power is weak.
▶
If the "Filter inspection indicator" is on, turn off the emergency switch
and clean the dustbin.
▶
When there's too much dust in the dustbin, suction power may get
weakened. Turn off the emergency switch and empty the dustbin.
▶
If the intake (on bottom of POWERbot) is blocked by foreign matters,
turn off the emergency switch and remove foreign matter from the
intake.
▶
When noise suddenly increase, turn off the emergency switch and
empty the dustbin.
the PoWeRbot cannot find
the charger.
▶
Check if there's power failure or whether the power plug is unplugged.
▶
Remove any obstacles around the charger that may disturb POWERbot
from returning to the charger.
▶
When there's foreign matters on the charge pins that affects charging,
clean the foreign matter.
the PoWeRbot suddenly
cleans diagonally.
▶
Check if the charger is installed along the grain of wooden floors or tiles.
▶
It may clean in diagonal direction for moving to another area in shortest
route, or it made contact with any obstacles in that angle, or if it was
charged at the charged at an angle, or grain of the wooden/tile floor is in
that direction.
Point cleaning is not
working.
▶
If you point the red light directly on POWERbot, it may not move to
desired direction.
-
Point the red light on the floor within 50 cm around POWERbot.
✻
✻
Do not use the point cleaning under direct sunlight, bright light or on
dark floors.
"Filter inspection indicator"
is on even after the dustbin
has been emptied.
▶
Use POWERbot after turning off the emergency switch and then turning
it back on.
▶
Empty the dustbin again and re-clean the filter thoroughly.
the PoWeRbot passes
through the Virtual guard.
▶
If the batteries are depleted, replace them. (2 type D (LR20) batteries)
▶
If the lamp is off, check if the Virtual guard is turned off and turn it on.
SR20H9050U-EN_DJ68-00716C-03_SA.indd 25
2015-02-05 오전 11:34:57
