Samsung SP-C802R, Руководство пользователя

Страница: 25 / 30

Anything wrong with the telephone?
The telephone does not
work at all.
There is no dial tone
when I pressed
button.
Station call and/or
flash does not work.
Messages are not recorded
even though the auto answering
machine is turned on.
Morning call does not
work.
● Make it sure that the telephone is
correctly installed. (See Page 8)
●
Make it sure that the adaptor is
properly installed according to
the specified voltage. (See Page 8)
● Make it sure that the the battery
is correctly placed in the remote
set. (See Page 9)
● Did you charge the remote set
battery enough? (See Page9)
● Is the remote set power ON?
(See Page 8)
● Make it sure that the telephone
line is correctly connected.
(See Page 8)
● Make it sure that the power cord is
properly connected. (See Page 8)
● Check the speaker volume.
(See Page 17)
● Make it sure that the telephone is
properly installed. (See Page 8)
● Register the remote set to the
base set again. (See Page 43)
●
Did you designate the extension
numbers when you purchased
additional remote sets to use? (See
Page 43)
● There are too many messages
recorded to record any more
message.
●
Delete the checked messages.
(See Page 21)
● Is the current time set in the unit?
(See Page 12)
●
Is the morning call time set?
(See Page 19)
●
Is the morning call function
activiated? (See Page 19)
● Is the base set/remote set in use?
(See Page10)
●
Did you charge the remote set
battery enough?
● Make it sure that the remote set
is properly installed.
(See Page 8)
● Did you charge the remote set
battery enough? (See Page 9)
● Did you registered the remote set
to the base set?
(See Page 43)
● Is the remote set power ON?
(See Page 8)
● Press button and you can
get clear speech quality.
(See Page 11)
● Make it sure that the remote set
isn
’
t too far from the base set.
(See Page 11)
● Erect the base set antenna.
●
Change the base set installation
location.
● Check the battery in the remote
set. (See Page 9)
● Did you charge the remote set
battery enough? (See Page 9)
●
Is the remote set power ON? (See
Page 8)
●
Register the remote set to the base
set again. (See Page 43)
● Make it sure that the CHARGE
contact is clean.
● If the CHARGE contact is dirty, the
unit may not be charged properly.
Clean the CHARGE contact with
cotton swap or eraser. (See Page 48)
● Make it sure that the adaptor is
installed properly according to the
specified voltage. (See Page 8)
● If the remote set is not properly
charged even after cleaning, purchase
a new battery from the service center.
(See Page 9)
● Check if the base set is busy.
Try to make a call after the base
set finishes its call.
● Make it sure that the remote set
isn
’
t too far from the base set.
Move closer to the base set. (See
Page 11)
●
is displayed on the remote
set LCD and the low voltage
warning is displayed, finish the
call immediately and then charge
the remote set enough before
using. (See Page 41)
There is warning tone
and I cannot make a call.
Cannot make a call
with the additional
remote set.
Cannot talk over the
remote set due to noise
and interference.
The remote set does not
ring.
The remote set is not
charged properly.
The remote set beeps
during call.
;;
;;
;;
@@
@@
@@
€€
€€
€€
ÀÀ
ÀÀ
ÀÀ
47 46