um-
0
OPER
9
WXYZ
1
Pick up the handset.
2
Press and .
3
Press .
4
Press .
5
Enter 4 digits Lock Code Number.
(The default lock code is preset to 0000 at the factory.)
NOTE
: If the code is correct, it sounds confirmation beep.
If not, it returns to the stand by mode with error beep.
6
set outgoing call restrict.
release outgoing call restrict.
1
Pick up the handset.
2
Press and .
3
Press .
4
(up) or (down).
NOTE
: This feature is automatically set after 3 seconds.
You will hear confirmation beep.
1
Pick up the handset.
2
Press and .
3
Press .
4
set 1-Minute Alert.
cancel 1-Minute Alert.
RESTRICTING USE OF THE PHONE
1
Pick up the handset.
2
Press and .
3
Press .
4
Press .
5
Enter 4 digits Lock Code Number.
(The default lock code is preset to 0000 at the factory.)
NOTE
: If the code is correct, it sounds confirmation beep.
If not, it returns to the stand by mode with error beep.
6
Press .
ADJUSTING VOLUME
TERMINAL RESET
You can control the sound volume on your phone.
Used when you wish to block outgoing calls from being made, but still
wish to receive incoming calls at any time. This feature can be disabled
and enabled through simple keypad number code entry.
Resets the terminal back to the initial service status of factory
pre-programmed state. This feature can be disabled and enabled through
simple keypad number code entry.
5
JKL
4
GHI
3
DEF
SETTING WARNING BEEPS
A discrete tone is generated after each minute interval into the call
conversation to notify you that a minute has passed since the beginning of
the call or after the previous time of discrete tone,
regardless of when you make or receive a call.
1
SCW-R500 1/9/99 12:06 PM Page 14
