SAMSUNG Proprietary-Contents may change without notice
5-7
Product Support Tools
5-4. CONVERSION TABLE OF FREQUENCY vs CHANNEL
T Y P E
CHANNEL
CONVERSION EQUATION
REMARK
TX
1
≤
N
≤
799
F=0.03
✕
N + 825.00
FREQUENCY
990
≤
N
≤
1023
F=0.03
✕
(N-1023) + 825.00
RX
1
≤
N
≤
799
F=0.03
✕
N + 870.00
FREQUENCY
990
≤
N
≤
1023
F=0.03
✕
(N-1023) + 870.00
Change to Test Mode
A. To change the phone’s state from Normal Mode to Test Mode, You should enter the following keys.
“ * 7 5 9 # 8 1 3 5 8 0 “
B. The command “0 1” is Suspend.
C. To finish the Test Mode, You should enter the command “0 2”.
* Note
: Make sure to change to “Digital only” or “Analog only” mode in NAM1,
EST MODE. (Refer to 4. NAM Programming)
Channel Selection and Tx Power Output Level Control
1. Digital Mode (CDMA)
A. Enter to Test Mode ( * 7 5 9 # 8 1 3 5 8 0 ).
B. “0 1” : Suspend.
C. “0 9 0 3 6 3 #” : Set to ‘0363’ channel.
D. “0 7” : Carrier On.
E. “3 4” : Spread spectrum to 1.23MHz band width.
F. “7 1 2 7 5 #” : Output RF power level setting.
“275” means AGC level and AGC level range is from 0 to 511.
2. Analog Mode ( FM )
A. Enter to Test Mode ( * 7 5 9 # 8 1 3 5 8 0 ).
B. “0 1” : Suspend.
C. “4 6” : Vocoder initial to Analog mode.
D. “0 9 0 3 8 3 #” : Set to ‘0383’ channel.
E. “0 7” : Carrier On.
F. “7 2 2 7 5 #” : Output RF power level setting.
“275” means AGC level and AGC level range is from 0 to 511.
G. “1 0 2” : RF Power level control, 2(0~7) means power level .
N ; CH NUMBER
F ; FREQUENCY
Содержание SCH-A105
Страница 2: ... Samsung Electronics Co Ltd July 2000 Printed in Korea Code No GH68 01246A BASIC ELECTRONICS ...
Страница 58: ...9 Block Diagrams SAMSUNG Proprietary Contents may change without notice 9 1 ...
Страница 59: ...SAMSUNG Proprietary Contents may change without notice 10 1 10 PCB Diagrams 10 1 Main PCB Top View ...
Страница 60: ...SAMSUNG Proprietary Contents may change without notice 10 2 PCB diagrams 10 2 Main PCB Bottom View ...