English - 23
SETTING
UP
2. Turn the bolt with a 4 mm
hexagonal L-wrench to
adjust the gap.
(Not provided)
3. Turn the bolt clockwise to (
) widen the
gap. Turn the bolt counter clockwise (
) to
narrow the gap.
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator. To help promote
better health, the water filter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms.
You may need to purchase a water purifying
system to do that.
In order for the ice maker to operate properly, a
water pressure of 138 ~ 862 kPa is required.
Under normal conditions, a 170 cc (5.75 oz.) cup
can be filled in about 10 seconds.
If the refrigerator is installed in an area with low
water pressure (below 138 kPa), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator is
properly filled. To do this, press the water dispenser
lever until the water runs from the water outlet.
• Water line installation kits are include with
unit. You can find it in freezer drawer.
• The new hose-sets supplied with the appliance
are to be used and that old hose-sets should
not be reused.
Parts for water line Installation
Water line fixer and screws
Pipe connector
Water line
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water line Installation Instructions in
the installation kit.
CAUTION
The water line must be connected to
the cold water pipe. If it is connected
to the hot water pipe, it may cause the
purifier to malfunction.
Close Main
Water pipe
Close Main
Water pipe
No gap
4. After connecting the water supply to the water
filter, turn your main water supply back on and
dispense about 3 L to clear and prime the water
filter.
DA68-03013B (EN)-06-���.indd 23
2015. 8. 26. �� 10:00
