setting up
_13
02
SETTING
UP
1.
Pull out the freezer drawer (
1
), then you can
see the lower hinge (
2
).
2.
Insert a philips screwdriver (+) (
3
) into the
shaft (
4
) of the lower hinge.
3.
Adjust the height by turning a philips
screwdriver (+) (
3
) clockwise (
DOWN
) or
counterclockwise (
UP
).
• When you turn a philips screwdriver (+)
counterclockwise (
UP
), the door will
move up.
1
2
3
4
3
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator. To help promote
better health, the water filter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20~125psi (138~862 kPa) is required.
If the refrigerator is installed in an area with low
water pressure (below 20psi), you can install
a booster pump to compensate for the low
pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled. To do this, press the water
dispenser lever until the water runs from the water
outlet.
• Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper
tubing and a ¼” compression nut.
• Use the new hose-sets supplied with the
appliance only. Do not re-use an old hose set.
Keep ventilation openings, in the
appliance enclosure or in the built-in
structure, clear of obstruction. Connect
to potable water supply only.
Connecting to the water supply line
1.
First, shut off the main water
supply.
2.
Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Pipe clamp
Cold water line
Shut off valve
3.
Connect the water line installation kit to the
shut off valve.
Shut off valve
Pipe clamp
Cold water line
Water line installation kit
Connecting the water supply line to
the refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Use Copper Tubing
Use Plastic Tubing
• ¼” copper tubing
• ¼” compression nut (1pc)
• Ferrule (2pc)
• ¼” plastic tubing
- Molded end(Bulb)
• ¼” compression nut (1pc)
WARNING
DA68-02601A-16.indb 13
2018. 10. 8. 오후 4:32
Содержание RF263TEAESG/AA
Страница 92: ...mémo DA68 02601A 16 indb 30 2018 10 8 오후 4 33 ...
Страница 93: ...mémo DA68 02601A 16 indb 31 2018 10 8 오후 4 33 ...