Samsung POWERbot R9350, Руководство пользователя

Страница: 32 / 116

ENGLISH-
32
troubleshooting
Symptom checklist
the PoWeRbot is not
working at all.
f
Check if the emergency switch is on.
f Check if all the icons are displayed on the display panel.
f Check if the POWERbot's battery is depleted.
-
When "Lo" is displayed, carry POWERbot to the docking station to
charge it.
f
Replace the batteries (AAA type) if the remote control is not working.
the PoWeRbot has stopped
during cleaning.
f When "Lo" is displayed on the display panel, carry POWERbot to the
docking station to charge it.
f
When POWERbot is immobilized by an obstacle such as a cord,
threshold etc, pick it up and move it away from the obstacle.
-
If any fabric or string is caught in a drive wheel, turn off the emergency
switch and remove the fabric or string before using it again.
Suction power is weak.
f
If the "Filter inspection indicator" is on, turn off the emergency switch and
clean the dustbin.
f
When there's too much dust in the dustbin, suction power may get
weakened. Turn off the emergency switch and empty the dustbin.
f
If the intake (on bottom of POWERbot) is blocked by foreign matter, turn
off the emergency switch and remove foreign matter from the intake.
f
When noise suddenly increase, turn off the emergency switch and empty
the dustbin.
the PoWeRbot cannot find
the docking station.
f
Check if there's a power failure or whether the power plug is unplugged.
f
Remove any obstacles around the docking station that may prevent
POWERbot from returning to the docking station.
f
When there's foreign matter on the charge pins, charging can be
affected. Clean the foreign matter off the pins.
the PoWeRbot suddenly
cleans diagonally.
f
Check if the docking station is installed along the grain of wooden floors
or tiles.
f
The POWERbot may clean in a diagonal direction if it is moving to
another area using the shortest route. It may also move at a diagonal
if it made contact with an obstacles at that angle, if it was charged at
the docking station at an angle, or if the grain of the wooden/tile floor
skewed is in that direction.
Point cleaning is not
working.
f
If you point the red light directly at POWERbot, it may not move in
desired direction.
-
Point the red light on the floor within 4 ft (1 m) of POWERbot.
✻ ✻
Do not use point cleaning in direct sunlight, under bright light, or on dark
floors.
"Filter inspection indicator"
is on even after the dustbin
has been emptied.
f
Turn off the emergency switch and then turn it back on.
f
Empty the dustbin again and re-clean the filter thoroughly.
SR9300K_3ge_DJ68-00743A-06_AA.indb 32 2018-02-13 오후 5:01:31