CHAPTER 2.
Ошибка! Используйте вкладку "Главная" для применения
제목
1,
장
제목
1 к тексту, который должен
здесь отображаться.
2-8
© SAMSUNG Electronics Co., Ltd.
The components on the front panel of the MP10/10a/11 boards have the functions below:
Table 2.5 Ports and LEDs of MP10/10a/11 Boards
Ports and LEDs
Functions
P1~P4
Subscriber connection port of 4DLMI/4SWM
MISC
Port to connect Ext PAGING, DRY CONTACT and Ext MOH
LAN
Port to connect 100 BASE-T LAN
WAN
Port to connect 100 BASE-T WAN (only MP11)
SIO
Port connect to serial I/O for development tool
Media Card
Port to insert an MMC+/SD card, which is a storage media
RUN LED
Status of Main CPU operation
- Off: No-power
- On (Green): On Booting, Reset
- Blink (Green): Normal Operation of Program
- Blink (Red): Fan module failed Operation of Program
- Blink (Orange): Push the reset button under the 7sec (MP10a, MP11)
- On (Orange): Push the reset button over the 7sec, DB clear (MP10a, MP11)
LAN LED
Status of LAN operation
- Off: Link and no-connection of LAN port
- On (Green): Link and LAN port connection
- Blink (Green): Tx/Rx Data through LAN port.
WAN LED
Status of WAN operation (MP11)
- Off: Link and no-connection of WAN port
- On (Green): Link and WAN port connection
- Blink (Green): Tx/Rx
MC LED
Status of MMC+/SD card operation
- Off: Non-mounted MMC+/SD card
- On (Green): Mounted MMC+/SD card
- Blink (Green): In Tx/Rx of MMC+/SD card
- On (Red): If the Media card is installed but not detected
RST
Button for resetting board and DB clearing.
Caution for Media Card(MMC+/SD card)
If possible, don’t remove the Media Card.
After dismounting Media card by MMC 817, eject Media card or power off if
necessary. Otherwise, Media card may be damaged.
After dismounting operation, MC LED is off. (MP10a/11)
When MC LED is red, remove the Media card and insert it again. (MP10)