Samsung NSG6 83 Series, Руководство пользователя

Страница: 46 / 168

46 English
Tr
ouble
shoo
ting
Troubleshooting
Surface burner
Problem Cause Action
All burners do not
light. The power cord is
not plugged into the
electrical outlet. Make sure the electrical plug
is plugged into a live, properly
grounded outlet.
A fuse in your home
may be blown or the
circuit breaker may have
tripped. Replace the fuse or reset the
circuit breaker.
The gas supply is not
properly connected or
turned on. See the Installation
Instructions that came with
your range.
Surface burners do
not light. The control knob is not
set properly. Push in the control knob and
turn it to the Lite position.
The burner caps are not
in place.
The burner base is
misaligned. Clean the electrodes.
Put the burner cap on the
burner head.
Align the burner base.
Surface burner
clicks during
operation. The control knob has
been left in the Lite
position. After the burner lights, turn
the control knob to a desired
setting.
If the burner still clicks, contact
a service technician.
The burners do not
burn evenly. Surface burner
components and caps are
not assembled correctly
and level. See page 39 .
The surface burners are
dirty. Clean the surface burner
components.
(See page
39 .)
Problem Cause Action
Very large or
yellow surface
burner flames. The wrong burner orifice
is installed. Check the burner orifice size.
Contact your installer if you
have the wrong orifice (LP
gas instead of natural gas or
natural gas instead of LP gas).
Surface burners
light but oven
burners do not
light. The oven door lock is
turned on. The display will show the Lock
icon. Hold the oven door open
and press
for 3 seconds.
The oven will beep and the
Lock icon will turn off.
The Gas Pressure
Regulator shut off switch
is in the off position. Call a qualified service
technician.
Oven
Problem Cause Action
The oven control
beeps and displays
an information
code. There may be an issue
with your oven. See the
“
Information codes ” chart
on page 50 .
Press Stop/Clear , and then
restart the oven.
If the problem persists,
disconnect all power to the
range for at least 30 seconds
and then reconnect the power.
If this does not solve the
problem, call for service.