Samsung NA24T4230FS, Руководство пользователя

Страница: 11 / 80

English
11
Using the c
ookt
op burner
s
Using the cooktop burners
Ignition
Manual ignition
If there is a power failure, you can ignite the burner manually. Use caution when
doing this.
1.
Hold a long gas grill lighter to the cooktop burner you want to light.
2. Push in the control knob for that burner, and then turn it to the Lite position.
Turn on the grill lighter to ignite the burner.
3. After the burner is lit, turn the control knob to adjust the flame level.
Flame level
The flames on the burners should always stay under the cookware, and should not
extend beyond the cookware bottom at any time.
WARNING
• Flames larger than the cookware bottom may result in a fire or physical injury.
• When you set a burner to simmer, do not turn the burner knob quickly. Watch the
flame to make sure it stays on.
• After turning on a surface burner, make sure that the burner is ignited. Adjust the
level of the flame by turning the burner knob.
• Always turn off the surface burner controls before removing cookware. All
surface burner controls should be turned OFF when you are not cooking.
• Always turn the burners off before you go to sleep or go out.
• If you smell gas, turn off the gas to the cooktop and call a qualified service
technician. NEVER use an open flame to locate a leak.
• If you turn the knob, but the surface burner does not ignite, turn off the control
knob immediately.
• Do not operate the burner for an extended period of time without cookware on
the grate. The finish on the grate may chip without cookware to absorb the heat.
• Be sure the burners and grates are cool before you place your hand, a pot holder,
cleaning cloths or other materials on them.
NA5300R_DG68-01132A-00_EN.indd 13 2019-04-19 4:46:11
2
1
1.
2.
3.
4 .
Fully press down the control knob for
the corresponding cooking position and
turn it to the left
, to the Lite position ,
and hold it here for a few seconds at
most until the burner ignites
.
A fter igniting , keep the control knob
pressed for about 5-8 seconds more
because the heat sensor that opens the
gas channel has to warm up first. Set
control
knob to the position you want .
Repeat steps 1 and 2 to check the
operation of each cooktop burner in
succession.
The flame size can be set continuously
between maximum and minimum by
slowing turning the control
knob .
Make sure all cooktop burners are properly
installed. To light a burner: