Samsung MWR-WH00, Руководство по установке

Страница: 6 / 32

E-
6
Installing the Wired remote controller (Continued)
1 Open the wired remote controller by pushing up the top cover of the remote controller while
holding the rear cover firmly. The wired remote controller opens in the way of slide.
2
Install the rear cover of the wired remote controller on the wall with the supplied screws. After
that, arrange the power cables on rear side of the front cover.
3 Connect the yellow and orange wires from the wired remote controller to the power cable
(V1, V2) of indoor unit. Connect the red and blue wires to the communication cable (F3, F4) of
indoor unit.
4 Reassemble the wired remote controller.
When you reassemble the wired remote controller, match the grooves on the left side.
Installation
More than
30mm
Screw hole
Rear cover

Before fixing the rear cover, clear
30mm of space on the top and
60mm on the right side.

Fasten the screw in the screw hole.
Front cover
More than
60mm
Connector type cable connection Terminal type cable connection
 
When using an extension cable, make sure that the communication cable and the
power cable is installed separately.
(If not, it may cause malfunction of the wired remote controller.)

Power cable of the wired remote controller(V1,V2) should be connected to the one
indoor unit only.
Housing
Tighten the
cable with the
wire joint
(accessories)
tightly.
Indoor unit
Multi function
wired remote
controller
Communication
cable(F3, F4)
F3 F4
Power cable
(V1, V2)
Indoor unit
Multi function
wired remote
controller
Communication
cable(F3, F4)
Power cable
(V1, V2)
MWR-WH00_IM_E_31218-2.indd 6 2010-02-25 ｿﾀﾈﾄ 1:54:34