16 English
S
tep-b
y
-s
tep ins
tallation g
uide
Step-by-step installation guide
Bolt End
Mounting
Plate
Toggle
Bolt
Wall
Toggle Wings
3.
Place the mounting plate against
the wall, pinch the wings of each
toggle together, and then insert the
toggle wings of each toggle into and
through the holes in the wall.
NOTE
Before tightening the toggle bolts and
wood screw, make sure the bottom
of the Mounting plate runs along the
bottom Horizontal line of the “Rear wall
Template” and the Mounting plate is
properly centered under the cabinet.
CAUTION
Be careful to avoid pinching your fingers
between the back of the mounting plate
and the wall.
4.
Tighten all bolts. Pull the plate away
from the wall to help tighten the
bolts. Tighten the screw.
C. Use the top cabinet template to prepare the cabinet above
You need to drill holes for the top support screws and a hole large enough for the
power cord to fit through.
•
Read the instructions on the TOP
CABINET TEMPLATE.
•
Tape it underneath the top cabinet.
•
Drill the holes, following the
instructions on the TOP CABINET
TEMPLATE.
CAUTION
Wear safety goggles when drilling holes
in the cabinet bottom.
A. Prepare the rear wall for outside back exhaust
You need to cut an opening in the rear wall for outside exhaust.
C
L
•
Read the instructions for outside
back exhaust on the REAR WALL
TEMPLATE.
•
Tape the REAR WALL TEMPLATE to
the rear wall.
•
Cut the opening, following the
instructions on the REAR WALL
TEMPLATE.
CAUTION
Do not cut an opening in the rear wall
if you are installing the microwave with
vertical duct or non-vented ductless
ventilation.
B. Attach the mounting plate to the wall
Attach the plate to the wall using toggle
bolts. At least one wood screw must be
used to attach the plate to a wall stud.
1.
Remove the toggle wings from the
bolts.
2.
Insert the bolts into the mounting
plate through the holes designated
to go into drywall, and then reattach
the toggle wings so that ¾˝ of the
bolt protrudes beyond the wing.
Install_ME11A7510DS_AA_DE68-04709A-00_EN+MES.indb 16
Install_ME11A7510DS_AA_DE68-04709A-00_EN+MES.indb 16
2021-06-16 10:55:30
2021-06-16 10:55:30
