9
ENGLISH
PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE
MICROWAVE ENERGY
Failure to observe the following safety precautions may result in harmful
exposure to microwave energy.
(a)
Under no circumstances should any attempt be made to operate the
oven with the door open or to tamper with the safety interlocks (door
latches) or to insert anything into the safety interlock holes.
(b)
Do not place any object between the oven door and front face or allow
food or cleaner residues to accumulate on sealing surfaces. Ensure that
the door and door sealing surfaces are kept clean by wiping after use
first with a damp cloth and then with a soft dry cloth.
(c)
Do not operate the oven if it is damaged until it has been repaired by a
qualified microwave service technician trained by the manufacturer. It is
particularly important that the oven door closes properly and that there
is no damage to the:
(1)
Door (bent)
(2)
Door hinges (broken or loose)
(3)
door seals and sealing surfaces
(d)
The oven should not be adjusted or repaired by anyone other than
a properly qualified microwave service technician trained by the
manufacturer.
This product is a Group 2 Class B ISM equipment. The definition of group
2 which contains all ISM equipment in which radio-frequency energy is
intentionally generated and/or used in the form of electromagnetic radiation
for the treatment of material, and EDM and arc welding equipment.
For Class B equipment is equipment suitable for use in domestic
establishments and in establishments directly connected to a low voltage
power supply network which supplies buildings used for domestic
purposes.
INStaLLING yoUr mICroWavE ovEN
Place the oven on a flat level surface 85 cm above the floor. The surface
should be strong enough to safety bear the weight of the oven.
1.
When you install your oven, make sure there is
adequate ventilation for your oven by leaving at least
10 cm (4 inches) of space behind and, on the sides
of the oven and 20 cm (8 inches) of space above.
2.
Remove all packing materials inside the oven.
Install the roller ring and turntable.
Check that the turntable rotates freely.
3.
This microwave oven has to be positioned so that plug is accessible.
If the supply cord is damaged, it must be replaced by a special cord or
assembly available from the manufacturer or its service agent.
For your personal safety, plug the cable into a 3-pin, 240 Volt, 50 Hz,
AC earthed socket. If the power cable of this appliance is damaged, it
must be replaced by a special cable.
Do not install the microwave oven in hot or damp surroundings like
next to a traditional oven or radiator. The power supply specifications
of the oven must be respected and any extension cable used must
be of the same standard as the power cable supplied with the oven.
Wipe the interior and the door seal with a damp cloth before using your
microwave oven for the first time.
10 cm
behind
20 cm
above
10 cm on
the side
ME0103MB_XSA-03323A_EN.indd 9
2010-08-19 2:46:32
