3-2
Chapter 3
Installing the InfoRanger
Installing
The InfoRanger should be installed on a flat surface away from direct rays of
light. It should also be close to the cable outlet or cable
splitter for easier connection of cables. Then slot
the InfoRanger into the provided stand holder.
Figure 3-1 Slotting the InfoRanger into the stand holder
Connecting the Coaxial Cable
Connect the coaxial cable from the InfoRanger
CABLE
connector to the cable
outlet or cable splitter. Slide pin in the center of the coaxial cable into the hole in
the
CABLE
connector carefully without bending, and turn the connector
clockwise until the cable is firmly attached.
Figure 3-2 Connecting the coaxial cable to the CABLE connector
Содержание InfoRanger SCM 110R
