· 5 · English
ID SET
1.
Connect the power cables of main unit, subwoofer and SWA-8000S.
2.
Press the
ID SET
button on the rear of the subwoofer and the SWA-8000S with a small, pointed object for 5
seconds.
c
The STANDBY indicators turn off and the LINK indicators (Blue LEDs) blink quickly.
3.
Press the
button on your remote control for 5 seconds while the main unit is turned OFF.
4.
The ID SET message appears on the display of the main unit for a short period of time, and then disappears.
5.
While the subwoofer's and the SWA-8000S's indicator are flashing blue, press the
button on your remote
control or on the right side of the main unit to turn on the main unit.
6.
The connection is complete if the blue LEDs on the subwoofer and the SWA-8000S stop blinking and glow
continuously.
c
If the connection process fails, the blue indicators will flash continuously. Go back to Step 2 and start again.
CONNECTING THE SURROUND SPEAKERS
SURROUND SPEAKERS OUT
SPEAKER IMPED
ID SET
L
R
Surround Speaker (L)
Surround Speaker (R)
Wireless Receiver Module
c
Place these speakers to the side of your listening position. If there isn't enough room, place these speakers
so they face each other. Position them about 60-90 cm above your ear, facing slightly downward.
c
Surround speakers must be connected to the wireless receiver module.
c
Each speaker has a colored label on its back or underside. Each cable has a single colored band near its
end. Match the band on each cable to the speaker label by color, and then connect the cable to the
speaker.
