English
19
|
03
Connections
1.
Follow the 1 to 3 steps as shown on the previous page.
2.
With the product turned off, insert the TX card into the TX Card
Connection (
WIRELESS
) on the back of the product.
• Hold the TX card so that the label "WIRELESS" faces upward
and insert the card into the port.
• The TX card enables communication between the product and
the wireless receiver module.
3.
Connect the left and right surround speakers to the wireless
receiver module. Again, match the colour of the plugs to the jacks
on the wireless receiver module.
4.
Plug the power cord of the wireless receiver module into the
wall outlet.
5.
Turn on the product. The product and wireless receiver module will now communicate with each
other and you will hear sound from the Surround speakers.
|
CAUTION
|
If you want to install the product on the wall, fasten the screws or nails on the wall firmly and use the holes on the rear of speaker to install.
However, when you install it, accessories (nails or screws) and installation is not provided by the company.
Do not let children play with or near the speakers. They could get hurt if a speaker falls.
When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct. (HT-E4530/HT-4550 only)
Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands or alien substances into the duct (hole)
of the subwoofer speaker.
Do not hang the subwoofer on the wall through the duct (hole).
Do not insert any other card except the TX card dedicated to the product.
If you insert a different TX card, you can damage the product and may not be able to remove the card easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the product is turned off. Inserting the card when it is turned on may cause a problem.
The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture.
For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions.
If you hear no sound from the wireless surround speakers, switch the mode to Dolby Pro Logic II.
In 2-CH mode, you will hear no sound from the wireless surround speakers.
|
NOTE
|
If you place a speaker near your TV set, the screen colour may be distorted because of the magnetic field.
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the product, sound
from the speakers may be disrupted because of interference.
If you use a device such as a microwave oven, wireless LAN Card, or any other device that uses the 2.4/5.8GHz frequencies near the
product, sound from the speakers may be disrupted because of interference.
The maximum transmission distance from the product to the wireless receiver module is about 33 feet (10m), but may vary depending on
your operating environment. If a steel-concrete wall or metallic wall is between the product and the wireless receiver module, the system
may not operate at all, because the radio wave cannot penetrate metal.
If the product doesn't make a wireless connection, you need to run an ID Set between the product and wireless receiver module. With the
product turned off, press "0"
"1"
"3"
"5" on the remote control. Turn on the wireless receiver module. Then, press and hold the “
ID
SET
” button on the back of the wireless receiver module for 5 seconds, and then turn the product on.
5V 350mA
LAN
WIRELESS
WIRELESS LAN
HDMI OUT
TX card
HT-E4500_XU_0316.indd 19
HT-E4500_XU_0316.indd 19
2012-03-16 오후 7:07:03
2012-03-16 오후 7:07:03
